John Deere 755B Crawler Operating the Machine – Return to Dig Position

You will need to position your bucket teeth, put them in position to where strips are at least .6 in above the ground – without bucket teeth level with the ground.
Always make sure to stop the engine but you can leave key in ignition switch in the ON position.
Set a gap between indicator plate to channel (A) switch to magnetic actuator (E) and cylinder head end tube end to support bracket plate (I).
You can loosen magnetic actuator (G) and move it forward until switch indicator light come on. Then move the actuator rearward until indicator light goes off. Tighten up the screws.
If light is already on after the gaps were set, move the actuator rearward until indicator light is off. Tighten screws.
Loosen the indicator plate (B) cap screws and position even with the end of the support channel (K). Tighten up the screws.
Then start engine and check your adjustments you made.

call 800-361-0068 for any questions or comments
sales@hydrostatic-transmission.com