P125 Series Oil Hydraulic Pump – Bearing Carriers

This tandem pump assy. goes up to 86 GPM may be pushed along to the second section thru the bearing carrier in codes an A and U only. Each of the pump sections are started up by the main inlet port in the front gear housing.  The total velocity thru the inlet must not go past 8-10fps in these cases of codes A and U bearing carriers need to be used in the place of codes C and D.

Codes

tandem pump use A, C, D or U

tandem motors use B code.

On tandem units (+) while they are going thru a gear section of a bearing carrier from an adjacent sections, codes A and U bearing carriers need to be use in place of codes C and D.

Pumps or motors ordered from Codes shown below will use these kinds of threads