You have model PD and PDC, that can split a single flow of hydraulic oil using these units. The flow percentage coming from the outlet ports stay the same even in load differences in between the ports. Most of these ratios are set at the factory but you can have them adjusted to 90/10 if available.

On the PD series the flow can’t be reversed, since it is a divider not a combiner.

PDC combiner series can have the combiner spool assy switched to a regular spool. You can divide the flow and you can take the flow and reverse the direction and match up to go in both directions. If you want other combinations you will need to get ahold of the factory.

These dividers will split the inlet flow to a 10% of the output flow when it is used in the specs that provided. Neither of these should be confused with a flow regulator. An actuator can shift the fluid that is different from the ratio of the divider and lockup. It is recommended that re phase the actuator.

Capacity of low flow models……………………………..5-20 GPM Capacity of high flow models……………………………20-35 GPM Maximum Operating Pressure…………………………2500 PSI

Some other characteristics:

Cross Drilled shifting spool – gives exact metering Six percentages to use on these models High Tensile Pressure compensated Both models can match up and go in both directions

Give us a call if you need more information on these units or you may need a divider ordered. Call us at 800-361-0068

sales@hydrostatic-transmission.com