Vickers Fixed Displacement Piston Motor Part 1

Part numbers that have a symbol out beside them come only in service kits.
The shims provide .000-0.004 inch shaft end play. The shaft needs to be rotated under preload to align the bearing rollers at both ends before setting them into play.
As a word of advise:
Don’t grease seal parts. Instead clean thoroughly with clean system fluid. Orings need to be lubricated with viscosity improver “STP” or something similar.
The shaft run out doesn’t need to be any longer than .002 inches. T.I.R.
The slot in pin 172750 needs to be radial to shaft + or – 10 degrees.

If you need further help with instructions on this Vickers Motor, give us a call at
800-361-0068
sales@hydrostatic-transmission.com