John Deere Crawler 755B – Remove & Install a Hood and Cowl
At our Hydrostatic Pump Repair Site, we offer many types of Hydrostatic Transmission Repair and information relating to Hydrostatic Parts
Today we will discuss:
John Deere Crawler 755B
How to Install a Hood
You will need to take off the exhaust pipe, collar, side shields and air cleaner cap.
Disconnect latch (H) and take off screws (D) to remove hood (I).
Take apart the hood and repair/replace parts as they are needed.
Put the new isolators (F & J) using multi purpose adhesive.
Put the hood back on.
Put the side shields and air cleaner cap. Height difference between air clearner and hood needs to be .45 – .16 in. If you need to, adjust air cleaners position.
Put in the exhaust pipe and muffler.
A – knob
B – spring
C – spring pin
D – cap screw (3 used)
E – washer (3 used)
F – isolator
G – latch base (2 used)
H – latch (2 used)
I – hood
J – isolator
K – hinge
L – access door
M – latch strap
How to Remove and Install a Cowl
Make sure you turn of the battery disconnect switch to OFF position.
Take out the instrument panel.
Then take out the cowl. Repair or replace any parts as needed.
Install cowl (make sure to wipe it down, clean of debris) and instrument panel.
A – pin (2 used)
B – cap screw (8 used)
C – washer (8 used)
D – bracket (2 used)
E – cowl
If you need further assistance on this , please leave us a comment or call us at